Grease Trap, 15 Gal/Min, 65 lb Capacity, 2 in Connection

The precision molded Canplas Endura® Grease Interceptor offers an effective alternative to traditional metal grease interceptors and is engineered to conform to strict plumbing codes and is certified by the Plumbing and Drainage Institute.               

Injection molded in high quality thermoplastics the Endura® Grease Interceptor provides the best combination of lightweight and strength. Both the tank and lid utilize integral reinforcing ribs to enhance rigidity and impact resistance.

Unlike traditional grease interceptors, the injection molding process provides the Endura® Grease Interceptor with a completely integrated surface that will not corrode, chip or peel.                                                                                                                                                                       

The unique, patent pending baffle design provides superior grease retention and removal of solids, even under the most severe applications.

Performance

An integral ramp is molded into the bottom of the tank by the inlet baffle. The slope of the ramp is designed to direct the lighter than water components (grease and entrained air) upwards to the retention area facilitating faster and more efficient grease separation.

This unique, patent pending baffle design provides superior grease retention, outperforming other interceptors, even under the most severe applications.

Both the Inlet and outlet baffles are removable making tank cleaning quicker and easier.

The inlet baffle is designed to enhance standard grease separation by slowing the inlet flow and entraining air into the water. The entrained air helps the grease rise to the surface of the water in the grease retention area.

The outlet baffle assists in the removal of food particles as they fall to the bottom of the tank. This design removes up to 90% of the solids from the tank allowing for less time spent during cleaning and increased time between cleanings.

All Canplas Endura® Grease Interceptors are tested and certified to Standard PDI-G101 of the Plumbing and Drainage Institute.

Strength

The tank and baffles of the Endura® Grease Interceptor are injection molded in polypropylene providing the best combination of light weight and strength.

External reinforcing ribs on the one-piece, molded tank provide additional strength and rigidity for "in-floor" installations.

The grease interceptor cover has a light duty loading classification when tested to CSA Standard B79 .1. The design load of 440 pounds is sufficient for foot and light traffic only.

Strengthening cross ribs have been designed into the cover for maximum load bearing capability. The cover is injection molded in nylon reinforced polypropylene to further enhance rigidity and impact resistance. A nonskid surface is standard.

Unlike traditional grease interceptors, the Endura® Grease Interceptor is injection molded in engineered thermoplastics providing a completely integrated surface that will not corrode, chip or peel.

The cover is secured by quick disconnect latching system.

The lid contains a replaceable, o-ring sealing gasket to provide a positive, airtight seal. This o-ring is installed in a channel within the lid virtually eliminating the possibility of pinching and tearing.

With a continuous use operating temperature of 220º F (104º C) maximum, the Endura® Grease Interceptor is able to withstand even the most severe operating conditions.